Paddock Model #10 Guide & Parts List
Upper Model
(For Use Above the Table)
Lower Model
(For Use Below the Table)

Model #10 guides can be installed on any machine having at least 2" from back of blade to top guide post, and from back of blade to frame below table and will support blades from 1/4" to 3/4" wide. Ball bearing guide wheels are 1-1/2" O.D.

 
1.
 Wing Nut
2.
 Center Shaft
3.
 Body Casting
4.
 1/4" Set Screw
5.
 1/2" Top Guide Shaft
6.
 Lower Guide Bracket
7.
 Lower Guide Shaft
8.
 38 NPP Ball Bearing Wheel, double sealed*
9.
 1/4" x 7/8" Cap Screw
10.
 Washer
   
*Radial load rating in pounds (based on 1,500 hours minimum life)

 

1708 Central Avenue
Kansas City, KS 66102
1-866-340-3234
Fax 866-447-0090
All artwork & content of this page is copyrighted © Paddock Tool Co., Inc.. and A2Z WebWorks, 2000. All rights reserved.
This site created and maintained by: A2Z WebWorks